Hook up 2 receivers together

Ratings 3, 5 You don't No offense guy, but going and buying two more receivers is just about as smart as putting a screen door in a submarine. You can't hook up the output of one receiver to the input of another and gain more power.


  • dating miroku shotguns;
  • top dating apps by users.
  • connecting two receivers together - [Solved] - Home Audio!
  • who is little scrappy dating 2013.
  • gq online dating flowchart;
  • online dating the technology behind finding love.

Yoiu might get a pretty light show for a few minutes but your neighbors and your friendly neighborhood fire department might not like you. If power is what you want, then get ONE moderately priced receiver with preamp outputs. Then simply hook the preamp outs from your receiver to the inputs of the power amp.


  • Active Topics.
  • .
  • how do i hook two receivers together?!
  • Connecting Two Receivers [Solved] - Speakers - Audio?

Leprkon Audioholic General May 10, The Yamaha does not have line-level outputs that you could send to another receiver. I think the was the least expensive model in that line that does. If you do need more juice, you will need a different model of receiver and possibly a separate amp. Nomo Audioholic Samurai May 10, What you're looking to do requires a reviever with pre-outs to allow one reciever to feed signals to another to allow that or those units to power a set of speakers by itself.

Not familiar with the JVC units you have but the does not have them.

how do i hook two receivers together? | Audioholics Home Theater Forums

I'm assuming the subs you have are powered, so the output of the reciever has no bearing on their output. Best Advise don't mess with it. If you or your speakers are that power hungry you need to step up to separates or a reciever with preouts combinered with a power amp. How can I take advantage of the spare Sony receiver and send maximum power to each of the home theater speakers. However wondering if same could be achieved using 2 receivers.

ATMOS setup using multiple receivers for additional atmos channel

Appreciate all the ideas and help. If you're asking for technical help, please be sure to include all your system info, including operating system, model number, and any other specifics related to the problem. Also please exercise your best judgment when posting in the forums--revealing personal information such as your e-mail address, telephone number, and address is not recommended.

Usually pre-amp outputs are reserved for the upper-mid to higher level receivers and gets left off of entry level models. You're limited to only the power output of your second amplifier, not the combined power of your two amps. Pre-amping only pushes the signal through and doesn't add to it. Kind of like one person loading a shopping cart, then passing it over to a second person who gets it going.


  • Popular Forums;
  • best dating site for pakistani!
  • Connecting 2 A/V receivers?
  • jon snow and daenerys dating in real life!

Only the second person's power is used in the end. I can't think of any easy way to combine the power, short of splitting the input signals into both amps separately, then running dual speaker lines to each speaker. I'm pretty sure you'd still have issues if you did that too!

TVs & Home Theaters forum

You could power your towers from one receiver and the center and the surrounds from the second. The volume will be controlled by whichever is sending the pre-amps out to the other. Unless you have hugely inefficient speakers that would need tons of power, I'm not sure I wouldn't just use the extra receiver in another room to power a secondary system. Your question Get the answer.

What is the best way to connect 2 receivers together? Complicated

I have two receivers, an Onkyo HTS which is conencted to 5 speakers and a subwoofer. I was wondering how and if it is possible to connect the two so that they would play simultaneously and be controlled through one source. Is there a way to do this?